sowmya

HowToFunda was founded with the reasons that students, teachers, and parents were struggling to make the school models during the school or science exhibitions due to the complexity involved in making the model which is a hard nut to crack. In the current education system, the term science exhibition refers to science projects, science presentation and implementing the science working models as prototypes, which students to exhibit the learning made by the students. The science exhibition is a very important event to help the student to prepare towards science projects. The science exhibition helps the students in improving the presentation skills and also increases the interest in science or any other subject. Being the parent myself did not find the right content or information on the school project model in one place.

how to make smart rain sensor based basement water clearing system working model

by
rain sensor basement water clearing system working model - inspire award science project - diypandit

This model demonstrates an automated flood prevention solution using simple sensors and motor mechanisms. When rainwater is detected, the system activates a submersible pump to drain water from the basement, thus preventing flooding. This model is especially useful for urban smart homes, low-lying building basements, and monsoon-prone areas. The project combines basic electronics with environmental … Read more

how to make windvane working model for science project exhibition

by
windvane working model for science project exhibition - diy - diypandit - award winning project

A wind vane is a device used to show the direction of the wind. It is also called a weather vane. Wind vanes are usually placed on rooftops, towers, or poles, where the wind can blow freely. How it works: This simple wind vane model shows how we can measure wind direction using basic materials. … Read more

how to make greenhouse farming working model

by
greenhouse farming working model for science project exhibition - diy - diypandit

This model demonstrates how a greenhouse creates a controlled environment to help plants grow. It traps heat from sunlight using a transparent cover, maintaining a warm and moist atmosphere inside. Greenhouses are used in agriculture to grow plants even in cold weather or poor soil conditions. This DIY model shows the greenhouse effect, temperature control, … Read more

how to make number series working model for math’s project exhibition – math’s project – tlm – diy

by
number series working model for maths project exhibition - maths project - tlm - diy - craftpiller

To help students understand number patterns and sequences through an interactive and visual working model. This DIY TLM model allows learners to predict the next number in a series and understand the logic behind arithmetic or geometric sequences. Materials Required: How to Make – Step-by-Step: Model Version 1: Number Slider Model Version 2: Rotating Wheel … Read more

how to make simple filtration(3d) working model – chemistry project – science exhibition – diy

by
simple filtration(3d) working model - chemistry project - science exhibition - diy - craftpiller - t2

To demonstrate the basic process of filtration used in separating insoluble solids from liquids, using a 3D working model that simulates real-life laboratory filtration. Materials Required: How to Make – Step-by-Step: Scientific Principle: Filtration is a physical separation technique used to remove insoluble substances from liquids. It is commonly used in chemistry labs, water purification, … Read more