In this blog post I have given instruction on how to make water fountain(beautiful table top) using waste material bottle
Creating a water fountain working model using an All Out bottle and a DC water pump is a fun and creative project to make a simple indoor water fountain.
The All Out bottle will act as the base of the fountain, and the DC water pump will circulate water, creating a beautiful water display.
Here’s a step-by-step guide to making the model:
Materials you will need:
- Empty All Out bottle (or any similar plastic bottle)
- DC water pump (submersible or surface pump)
- Small pipes or tubes
- Wires and connectors
- 9V battery or AA/AAA batteries with battery holder
- Battery snap connector or terminal connector
- Decorative rocks or pebbles
- Hot glue gun or adhesive putty
Step-by-step instructions:
- Prepare the All Out bottle:
- Remove the cap and label from the All Out bottle. Make sure it is empty and clean.
- Position the DC water pump:
- Place the DC water pump inside the All Out bottle. If you are using a submersible pump, ensure that it is securely positioned at the bottom of the bottle. If you are using a surface pump, position it near the opening of the bottle.
- Create the water circulation:
- Use small pipes or tubes to connect the outlet of the water pump to the top of the All Out bottle, allowing water to be pumped from the bottle to the top.
- Allow the water to flow back into the bottle, creating a continuous water circulation.
- Add decorative rocks or pebbles:
- Place decorative rocks or pebbles inside the All Out bottle around the water pump. These will cover the pump and provide a visually appealing look to the fountain.
- Secure the components:
- Use a hot glue gun or adhesive putty to secure the water pump and tubes in place inside the All Out bottle. Make sure everything is firmly attached.
- Connect the water pump to the battery:
- Connect the positive (red) wire of the water pump to the positive terminal of the battery snap connector.
- Connect the negative (black) wire of the water pump to the negative terminal of the battery snap connector.
- Test the water fountain:
- Submerge the water pump (if it’s a submersible pump) or ensure that the water pump is positioned inside the All Out bottle (if it’s a surface pump).
- Connect the battery snap connector to the battery. The water pump will start pumping water, creating a water fountain effect inside the All Out bottle.
This model allows you to create a mini indoor water fountain that is not only visually appealing but also a fun and engaging way to learn about water circulation and the principles behind a water fountain’s functioning.
#howtomake #waterfountain #tabletop #wastematerial #bottle #diy #howtofunda