In this post I have written the instructions on how to make agriculture farming working model inspire award science project – diy – howtofunda
Creating an agriculture farming working model using a DC water pump, plastic tray, and cardboard is a great way to understand and demonstrate a simple irrigation system for plant cultivation.
Here’s a step-by-step guide to making the model:
Materials you will need:
- Cardboard or a sturdy base
- Plastic tray or container (to hold water)
- DC water pump (submersible or surface pump)
- Small pipes or tubes (to connect the pump to the tray)
- Wires and connectors
- 9V battery or AA/AAA batteries with battery holder
- Battery snap connector or terminal connector
- Small plants or pots (to represent the crops)
- Hot glue gun or adhesive putty
- Small stones or pebbles (to simulate soil or growing medium)
Step-by-step instructions:
- Design the base:
- Cut a large piece of cardboard or use a sturdy base to serve as the foundation for your agriculture farming model.
- Set up the plastic tray:
- Place the plastic tray or container on the base. This will serve as the water reservoir where the water will be pumped.
- Position the DC water pump:
- Depending on the type of water pump (submersible or surface), position it inside the plastic tray or near the edge to pump water from the tray to the crops.
- Connect the water pump to the tray:
- Use small pipes or tubes to connect the outlet of the water pump to the plastic tray. Ensure the pipes are securely attached to prevent water leakage.
- Add plants or pots:
- Arrange the small plants or pots on the cardboard base, representing the crops that will be irrigated. You can use small stones or pebbles to simulate soil or growing medium.
- Connect the water pump to the battery:
- Connect the positive (red) wire of the water pump to the positive terminal of the battery snap connector.
- Connect the negative (black) wire of the water pump to the negative terminal of the battery snap connector.
- Test the agriculture farming model:
- Connect the battery snap connector to the battery. The water pump should start pumping water from the plastic tray to the crops, simulating an irrigation system.
This model demonstrates a basic irrigation system that can be used in agriculture to water crops efficiently. It’s an educational project to learn about water management and sustainable farming practices.
#agriculturefarming #workingmodel #howtofunda #scienceproject #howtomake #inspireaward #inspire